Big Solutions for a small planet



Identification of the Substance/Preparation and Company.
Company: SMT-Surclean Main and Emergency Tel No: +44 (01983) 290333
SMT Technology Centre, Prospect Rd., Fax No: +44 (01983) 295499
Cowes, Isle of Wight, U.K. P031 7AD.
Composition/Information on Ingredients
General description: a mixture of solvent and water for the removal of residues in Electronics
Ionograph test systems.
Hazardous ingredients
Name of Ingredient Concentration CAS number Hazard phrases
Isopropanol Alcohol 99.7% 67-63-0 H225, H315, H319,H335, H336
Water remainder — N/A
Hazards Identification
-Odour: Slight fragrence
-Appearance: Colourless liquid
-Contact with skin: Prolonged skin contact will result in defatting of the skin, irritation, and possible
dermatitus, H315.
-Inhalation: Irritating to eyes and respiratory system (H319, H335. May cause dizziness, confusion,
headache or stupor, H336.
-Highly Flammable, H225.
First aid measures
Contact with skin
-wash the affected area with plenty of soap and water.
-afterwards, a suitable moisturising skin cream can be applied.
Contact with eyes
-If material has got into eyes, wash out immediately with plenty of water for at least 15 minutes.
-Seek medical attention if any irritation persists.
-Give patient plenty of water to drink. NEVER MAKE AN UNCONCIOUS PERSON VOMIT OR
-Seek medical attention immediately.
Inhalation and General
-Remove patient from source of exposure to fresh air & lie down. Seek medical advice if neccesary. If casualty
is unconcious, place into recovery position. Perform artificial respiration if breathing has stopped. If breathing is difficult,
trained personnel may assist by administering 100% Oxygen. Keep warm and at rest. Seek prompt medical attention.
Fire fighting measures
Extinguishing Media
-in case of fire use water spray or fog, alcohol resistant foam, dry chemical or C02 (S43), Sand, Dolomite etc.
Special Fire Fighting Procedures
-Do not use water jets. Wear breathing apparatus. Use Water to keep fire exposed containers cool and to
disperse vapours. Dike for water control. Cool containers exposed to flames with water until well after the fire is out. Move
container from the fire area if it can be done without risk. Use water spray to reduce vapours. For large scale fires in cargo
areas, use unmanned hose holder or monitor nozzles if possible. If not, withdraw and let fire bum out. If risk of water
pollution occurs, notify appropriate authorities.
Exposure hazards
-None known
Accidental release measures
Immediate actions
-Shut off all ignition sources. Avoid sparks, flames, heat and smoking. Ventilate.
Clean up procedures
-Provide ventilation and confine spill. Do not allow runoff to sewer. Absorb spillage in a suitable inert material
such as vermiculite, dry sand or earth and place into appropriate container. Avoid contact with skin or inhalation of
spillage, dust or vapour. Clean up personnel should use respiratory and liquid contact safety protection clothing.
Handling and Storage
Usage precautions
-Keep away from sources of ignition. Avoid spilling, skin and eye contact. Ventilate well, avoid breathing vapours.
Use approved respirator if air contamination is above accepted level. Wear full protective clothing for aged exposure
and/or high concentrations.
Storage Precations
-Low risk flammability/combustibility-keep away from oxidizers, heat and Names. Isolate from other materials.
Keep in a cool, dry, ventilated stage and dosed containers. Ground container and transfer equipment to eliminate static
sparks risk.
Storage Criteria
-Chemical storage.
Exposure Controls and Personnel Protection
Normal good room ventilation should be sufficient. Gloves and eye protection are recommended for prolonged or
repeated exposure.
Protective Equipment
-provide adequate general and local exhaust ventilation.
-No specific recommendation made, but respiratory protection must be used if the general
level exceeds the Occupational Exposure Level (OEL).
Protective Gloves
-Use protective Gloves. Chloroprene, Nitrile or Butyl Rubber Industrial grade Gloves.
Eye protection
-Wear approved safety goggles. Full face shield protecttion preferred.
Other Protection
-Wear appropriate clothing to prevent any possibility of liquid contact and repeated or
prolonged vapour contact.
Hygenic Work routines
-DO NOT SMOKE IN WORK AREA. Wash at the end of each work period and before
food consumption, smoking or using the toilet. Remove any clothing that becomes
contaminated immediately. Do not eat or drink whilst working with this material.
Physical and Chemical Properties
-colourless liquid
-Mild. Alcohol. Sweet.
Solubility Description
-Soluble in water.
Changes of state Value/range unit method
Boiling point/range 82 deg C.
Flash Point 12 deg C. Pensky Martens C.Cup.
Auto ignition temperature 425 deg C.
Explosion hazard
Explosion limits
-lower 2 % -upper 13.4 %
Vapour pressure
-43.2 hPa @ 20 deg. C.
-0.785 – 0.892 @ 20 deg. C.
PH Value
-3.1 mPas @ 20 deg. C.
Stability and Reactivity
-Avoid: heat, sparks, moisture and flames.
Materials to avoid
-Bases, Alkalies (Inorganic), Strong Oxidizing agents, Strong Reducing agents
Hazardous Decomposition products
-Material does not decompose up to the specified boiling point. Thereafter in case of fire, material can
create Vapours/gases/Fumes of: Carbon Monoxide (CO), Carbon Dioxide (C02).
Toxicological Information
Toxic Dose-LD50
-ingestion: No data is available for oral toxicity. The values of the ingredients are higher than LD50
(oral rat) : 5045mg/kg.
Skin Contact
-Repeated/prolonged contact causes degreasing, irritation and possible dermatitus.
Eye Contact
-Initial eye contact will cause chronic eye irritation. Inhalation -Higher concentrations can cause
irritation of the respiratory system, nausea and dizziness.
Ecological Information
-Dissolves in water. Product remaining on surface evaporates within one day. Larger volumes may
penetrate soil layer and could contaminate groundwater.
Does not significantly bio-accumulate.
-Material is readily bio-degradable meeting the 10 day window crriterion. Oxidizes rapidly by
photochemical reactions in air. This together with its very high flash point means it can be treated as a very
low VOC potential material. Integrated environmental half-life is estimated to be 1-< 10 days.
Acute Fish Toxicity LC50 test 9640 mg/l 96 hours (ref. US EPA).
-Practically non toxic. However best practice states material must not be drained.
Disposal Considerations
Disposal methods UK
-Dipose of in accordance with Local Authority requirements.
EEC waste listing class according to (94/3/EG). Dispose of in accordance with 2008/98EC.
-Disposal No. 140303 (Solvents/Solvent blends not containing Halogenated material)
Suggested disposal/recovery meths
Filtration waste should be collected and disposed of by licensed Chemical waste removal Contractors.
Specification of minor waste content will be mostly that of the production materials for which the
cleaning material was used. To advise the disposal contractor therefore, refer to the production
material data source.
Transport Information
Ground Transportation ADR/RID
-ADR/RID Class 3 Alcohols, n.o.s. (Cont. I.P.A.)
-item 31 C
-UN number 1219
Sea Transportation IMDG – Code
-IMGD Classification 3.3 Alcohols, n.o.s. (Cont. I.P.A.)
-page 3303
-UN number 1219
-Packaging class III
-EMS number 3 – 06
-MFAG 305
Air Transportation ICAO-TI and IATA-DGR
-ICAO/IATA Classification 3 Alcohols, n.o.s. (Cont. I.P.A.)
-UN ID number 1219 Packaging instructions – 309 / 60 I
-Packaging Class 111 – 309 / 10 I
-10 / 220 1 (Cargo Aircraft only)
Regulatory Information
Hazard Phrases
-H319,Harmful by inhalation, in contact with skin/eyes, and if swallowed.
-H335 Irritating to respiratory system.
-H336 May cause drowsiness or dizziness if inhaled.
-H225 Highly flammable liquid and vapour.
Precautionary Statements
-P210 keep away from heat,sparks, open flame and other ignition sources. Do not smoke.
-P305, P351, P338 IF IN EYES Rinse with water for several minutes. Remove any contact lenses
if present, then continue rinsing with water.
-P370, P378 IN CASE OF FIRE Use dry powder extinguisher or sand to extinguish.
-P403, P235 Store in a well ventilated place, out of direct sunlight. Keep cool.
Issue date and revision number
Issued on 29/02/2021. Issue revision 10.
This information relates only to the specific material designated and will not be valid for such material used in
combination with any other material or in any process. Such information is, to the best of the Manufacturers
knowledge and belief, accurate and reliable as of the date shown. However, no warranty, guarantee or
representation is made as to its accuracy, reliability or completeness. It is the users sole responsibility to
satisfy himself as to the suitability of such information for their particular application.

Shopping Cart
Scroll to Top